Fallout 4 Crucible: How To Get The Heavy Incinerator
There are a couple of new weapons available in Fallout 4 following the release of the next-generation update. One of them is the Tesla Cannon, which is looted through the Best of Three quest as well as the Echoes of the Past quest, giving you two chances to acquire it. The other weapon is the Heavy Incinerator, which is only obtainable through completing the Crucible quest.
To see exactly how to start and finish the Crucible quest in Fallout 4 so you can wield the Heavy Incinerator, take a look at the guide below.
Starting the Crucible quest in Fallout 4
First off, if your character has already progressed through some of the story in Fallout 4, the Crucible quest and all the other next-gen update content should be immediately available after downloading the update. However, players on new saves have to reach a specific point in the story before they can partake in all of the fresh content.
In any case, once you can start the Crucible quest, track it in your quest log. You’ll see that your first objective is to investigate Saugus Ironworks, located on the map’s eastern side, just south of The Slog. Upon reaching Saugus Ironworks, you’ll have to deal with a few enemies out in front of the building. Once they’ve been dispatched, head inside and defeat some more enemies that are located on the ground floor and on the platforms that go across the interior of the building.
Your goal inside is to reach a door on the upper level that’s locked via a terminal. Hack into the terminal to open the door and then find an enemy named the Forged Keeper. Defeat the Forged Keeper, who’s wielding a Flamer, and loot their body to find the Forged Keeper’s Note.
After reading the note, you’ll learn that the Forged acquired the Incinerator and tested it on their new recruits. The Keeper also scolded one of the recruits for trying to cheat the testing, and they said they put the evidence against this cheating recruit in a toolbox upstairs. When you read the note, a new quest marker appears that leads you to this toolbox, which requires Expert Lockpicking to get inside.
The toolbox contains a note from the cheating recruit, explaining that they tried to use some flame-resistant power armor legs not to get burnt by the Incinerator. The recruit says they buried the power armor legs below the crucible in the ironworks building. To get beneath the crucible, make sure you loot the Smelter Console Password from the toolbox and then head down to the ground floor to press the Molten Metal Flow Control button. You can also step into the Raider Power Armor suit that’s located behind the button and then go back upstairs to the Smelter Terminal.
Use the Smelter Console Password at the terminal and move the crucible from its resting place. This makes the crucible move forward on the ground floor and reveals the spot where the recruit hid the power armor legs. However, the recruit only managed to hide the blueprints for the flame-resistant power armor legs, meaning you need to craft the mod for each leg.
Fortunately, you can use the nearby power armor station on your new Raider Power Armor to build and attach the flame resistant legs. Just go over to the station, hop out of your power armor, press the “Craft” button on the station, and then go down to the right and left legs. Here, you can attach the flame resistance mod in the “Misc Mod” section. Don’t worry about the crafting materials for the flame-resistant leg mod, as the game automatically lets you craft it for each power armor leg.
With your new legs attached to the power armor suit, head over to the open smelter on the other side of the room, dip your toes into the flames, retrieve the Incinerator hanging by a chain, and get out. If you try to go into the smelter without using the flame-resistant power armor legs, you die instantly.
If you did everything right, you now have the Ghoul Slayer’s Heavy Incinerator. This completes the Crucible quest in Fallout 4.
